Insta360 X3 Sticky Lens Guards

Exclusively customized to fully protect the lens without fear of scratches.

Product Specifications

Main material: PMMA

Weight: 1.5g/piece

Size: 34.8x10.95mm (diameter x height)

Package Contents

Adhesive lens protector x 2

Double-sided adhesive sticker* x 2

Triangular opening pick x 1

Lens cleaning cloth x 1

*The lens protector is already attached with double-sided adhesive sticker by default

Instructions

1. Differentiate between the front and rear lens protectors: the thinner lens protector should be installed on the camera side, and the thicker lens protector should be installed on the camera logo side.
2. Stick the lens protector with double-sided tape to the lens, paying attention to the alignment of the circular holes. After sticking, press hard for 15 seconds to ensure that the lens protector fits the surface. If the sticking is not smooth, it will affect the waterproof and screen splicing.

Note:

1. Before use, please clean the periphery and surface of the lens to ensure that the adsorption surface is clean and dry. Make sure to install the lens protector only in a clean and dry environment. If there is foreign matter stuck to the lens or the surface of the lens protector, it will affect the camera shooting effect.

2. Before use, please distinguish the front and rear lens protectors: the thinner lens protector should be installed on the camera screen side, and the thicker lens protector should be installed on the camera logo side.

3. When pasting, please do not remove and paste again to avoid affecting the stickiness.

4. The lens protector is only splash-proof. If you need to shoot underwater, please use a dedicated diving housing or related accessories. When using a diving housing, please remove the lens protector first.

5. When removing the lens protector, please use the included triangular opening pick to remove it. When removing, be careful not to scratch the camera lens.

6. When replacing the double-sided adhesive sticker, please clean the old double-sided adhesive sticker first, make sure the C side of the lens protector is clean and flat, and then stick the new double-sided adhesive sticker to the groove on the inside of the lens protector, paying attention to the corresponding position of the round hole.