Insta360 Dual/Triple Suction Cup Car Mount

Compatible models

This car mount with dual/triple suction cups can only be used with the Insta360 High-Strength Invisible Selfie Stick. Do not use it with other selfie sticks.

Say goodbye to limitations with a unique third-person car view or other cinematic game-style perspective.

The triple suction cups form a triangular structure for maximum stability.

Dual suction cups are suitable for driving in the city and on flat roads.

The design combines three suction cups into one unit, which can be separated into a dual suction cup holder or a single suction cup holder as needed.

Product Specifications:

Dual/triple suction cup car mount x 1

Precautions:

1. Please install and use according to the following instructions. Do not attempt DIY or connect third-party accessories. Faults or damage caused by failure to follow the instructions are not covered by Insta360's warranty or replacement service.

2. This accessory is not recommended for use on public roads. Please ensure the surrounding road environment is safe before use.

3. This car mount with dual/triple suction cups can only be used with the Insta360 high-strength invisible selfie stick. Do not use it with other selfie sticks.

4. Please use this product in an ambient temperature range of 0-40°C (32-104°F).

5. Please try to install the suction cups on the same horizontal plane (or the plane with the least slope). If it is not possible to install them on the same horizontal plane, then the suction cups on both sides of the horizontal support rod must be attached to the same plane, and the suction cups on the extension support rod must be installed on another plane.

6. Before installing the suction cup, ensure the surface is smooth and clean.

7. When installing the suction cup, ensure it is fully attached to the flat surface. If the suction cup is not attached, loosen the knob, adjust the suction cup angle, reinstall the suction cup, and tighten the knob.

8. Observe the indicator line after installing the suction cup. If the indicator line returns to the outside of the pump body within a short time (the indicator line can be seen on the outside), there is an air leak, and the suction cup needs to be reinstalled.

9. After installing the complete bracket, ensure that all knobs on the bracket are tightened. Do not use the suction cup bracket if the knobs cannot be tightened, or if the suction cup adapter, telescopic support rod, or selfie stick connection is still not unlocked after tightening all knobs.

10. When using the device, if you need to stop for a break, please check the suction cup for any unexpected air leaks (you can see the indicator lines on the outside). If the suction cup is leaking, please reinstall it to prevent the tripod from falling and damaging the camera.

11. When removing the suction cup, use your fingers to pry the edge of the suction cup to create a gap between the suction cup and the surface, and you can easily remove the suction cup.

12. After use, if the surface of the suction cup gets dirty, it needs to be wiped clean in time to ensure that the suction cup can maintain sufficient adhesion for the next use.

13. When assembling this vehicle-mounted three-suction cup bracket, do not use it in excessively rugged off-road conditions (including but not limited to large rocks, very bumpy, steep mountain roads), and do not exceed 100 km/h (62 mph).

14. When assembling this vehicle dual suction cup bracket, do not use it on roads other than flat asphalt surfaces, and do not drive the vehicle at speeds exceeding 80 km/h (50 mph).

15. This product's suction cup uses a modular design. When using a single suction cup, it only supports connection to the Insta360 High-Strength Invisible Selfie Stick. Keep it in the retracted state; do not unfold the selfie stick.

16. When the selfie stick is fully extended while the vehicle is in motion, the dynamic load of the suction cup bracket is 300g. Please do not add heavy objects.

One-year maintenance

Vast World Limited (Insta360's exclusive distributor in Hong Kong and Macau)

Insta360 Hong Kong After-Sales Service Center and Repair Service