Insta360 Bike Headset Cap Mount

$319.00

Compatible models

GO Ultra
X5 / X4 / X3

Ace Pro 2 / Ace Pro / Ace

GO 3S / GO 3 / GO 2

ONE RS (Dual Lens/4K) / ONE X2 / ONE R / ONE X

Insta360 bicycle handlebar bracket
Insta360 Bike Headset Cap Mount

Standard Package

Contents include

1x Bicycle Handlebar Base

1x Universal Joint

2x bicycle handlebar screws (20/30 mm)

3x L-shaped hex wrenches (3/4/5 mm)

1x Hand-tightening screw

1x Three-jaw to 1/4" adapter

2 dust covers

2x Anti-slip Ring Kit

4x Anti-slip Rings

Selfie stick package

Contents include

1x Invisible Sports Selfie Stick (Extended Length = 100cm)

1x Bicycle Handlebar Base

1x Universal Joint

2x bicycle handlebar screws (20/30 mm)

3x L-shaped hex wrenches (3/4/5 mm)

1x Hand-tightening screw

1x Three-jaw to 1/4" adapter

2 dust covers

2x Anti-slip Ring Kit

4x Anti-slip Rings

Use it with the Panoramic Insta360 Action Camera and the Action Invisible Selfie Stick to capture incredible third-person perspectives.
This mount is only compatible with the Insta360 Motion Invisible Selfie Stick.
Use it with the Insta360 wide-angle action camera to create an immersive first-person POV experience.
Includes everything you need, and can be easily installed at home.
Securely attached to the head tube of a bicycle, it can replace any standard 28.6 mm (1-1/8 in) head cap.

Product Specifications

size:

74.17x74.12x53mm (2.92x2.91x2.08in)

Weight - Bicycle handlebar cap base:

31g (1.09oz)

Weight - Universal Joint:

140 g (4.93 oz)

Material:

Aluminum alloy, stainless steel, silicone, plastic

Precautions

This mount is only compatible with standard OD1 handlebars or forks with a diameter of 28.6 mm (12 in). It is not suitable for non-standard bicycles, non-circular handlebar head tubes, etc.
Before installing the camera, ensure the mount is securely attached to the bicycle. Tighten the mount using the included L-shaped hex wrench.
Before installing the bracket, ensure the nuts on the bicycle fork are secure. Star nuts or expansion plugs are recommended. Star nuts with insufficient friction or strength are not recommended as they may loosen. When using expansion plugs, place them 3-4 mm from the end of the bicycle handlebar stem.
Before tightening, install a set of anti-slip rings onto the bicycle handlebar cap mounting bracket.
After installation, cover the handlebar screws with a dust cover to prevent them from rusting.
After each use, please dry the accessories to prevent water or sweat from corroding them.
This product is designed for riding on flat roads at a maximum speed of 50 km/hr (31 mph). This accessory is not suitable for off-road use.
This mount is only compatible with the Insta360 Motion Invisible Selfie Stick. To ensure your safety while riding, if you need to extend the selfie stick, extend it horizontally and away from the wheels. The length should not exceed the front wheel.
If the bicycle is to be parked outdoors for an extended period of time, please remove the stand and store it properly.
Please install and use the accessory correctly according to these instructions. Do not attempt to DIY or connect third-party accessories. Damage caused by failure to follow the instructions is not covered by Insta360's warranty or replacement service.